6-1第六章 管道设计（Chapter 6 pipeline design）.docVIP

6-1第六章 管道设计（Chapter 6 pipeline design） This article is contributed by linnlg00 The PPT document may not have a good browsing experience at the WAP end. It is recommended that you choose TXT, or download the source file to the native view. Chapter vi Pipeline design one Pipeline design 6.1 the basic requirements of the design of the pipeline and the design of the pipe design of the pipeline design pipe design drawing pipeline stress analysis pipeline vibration 2 Preface: preface: pressure pipeline is introduced regulations on the special equipment supervision of special equipment supervisory regulations on pressure pipeline, refers to the use of certain pressure, the pressure piping, refers to the use of certain pressure, tubular device for conveying gases or liquids, or liquid tube equipment, the range of maximum working pressure is greater than or equal to 0.1 MPa (table) pressure of gas, liquefied gas, greater than or equal to (gauge pressure) gas, liquefied gas, steam medium or flammable, explosive, toxic, corrosive, steam medium or flammable, explosive, toxic, corrosive, the high standards of working temperature is higher than or equal to the boiling point of liquid medium, and high standards of working temperature is higher than or equal to the boiling point of liquid medium, and nominal diameter greater than 25 mm pipe. The pipeline. And nominal diameter is greater than the pipe does not press pressure pipeline management equipment ontology, military equipment, military equipment, transport, and device of the pipe (residential building, courtyard) at the door (residential building, courtyard) before the last line of the valve life after use a conduit burning gas and the heat point (not including the heat point) of life with conduit burning gas and thermal (not including the heat point) after 3 of the heat pipe Pressure pipeline is divided into three categories according to the use Enterprises, industrial piping, institutions subordinate to the transport proces