凯越ABS灯常亮（The ABS is always bright）.doc

凯越ABS灯常亮（The ABS is always bright） For jetta vehicle ABS warning light and hand brake light phenomenon, according to the control unit maintenance case most of the reasons is the failure, some cases also plug corrosion or loose caused the control unit 1. The reason for the light of the hand brake may be that the front brake is too thin, the brake oil is too little, and the hand brake switch fails. It can check the front brake, brake oil and hand brake switch. 2. The reason of the ABS lamp may be the problem of the wheel ring sensor of ABS and failure codes. The wheel ring sensor of ABS can be checked, the fault code is extracted and the fault code is removed. ABS or EBD failures Reply -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- The hand brake is bright with the ABS lamp, indicating that EBD has a malfunction and has just read the instructions See if the plug of the ABS pump is loose. It should have fallen off. The ABS system will not be able to light the two lights at the same time Subtraction power distribution (EBD) The system EBD system enables the rear brake to provide a greater proportion of the power, which maximizes the efficiency of each brake. It works by adjusting the load conditions and speed of the car to the rear wheels. EBD system is an integral part of the ABS system and USES some parts of the ABS system to perform the function of optimizing the distribution system. The EBD system will also cease to work if any ABS components used by the EBD function fail. When the EBD system is working, you may hear a tremor or a slight vibration of the brake pedal, which is normal and not a failure. The steps taken during the failure of the noil EBD system If the EBD system fails, the system will stop working and the brake system alarm lights and ABS alarm lights will be lit simultaneously. During driving, if the brake system alarm lights and ABS alarm lights are lit simultaneously, EBD system may fail. Even if the EBD system fails, the conv