变电题库（Substation question bank）.docVIP

变电题库（Substation question bank） 1. Fill in the blanks 1. Inspection of equipment inspection of transformer substation, generally divided into (general inspection) (inspection tour)) (special inspection) 2. The equipment for spare or to be used shall be considered as a running equipment for periodic (inspection) and (maintenance). 3, set control station during on duty personnel on duty should check in time to reduce the substation to upload information, every two hours for all (pictures), to reduce the substation (reports), () to upload information comprehensive check one more time. 4. The battery shall be checked (voltage) and (temperature) in accordance with the regulations, whether the connection is fastening, whether there is heating or oxidation, whether the battery container is (broken) and (leakage). 5. The touring project of the substation in the backstage machine: should inspect the main wiring diagram to match the position of the (actual device), and the remote measurement shows that it is correct. Deal with alarm window, event order record, (to protect the event log), remote communication shift record, alarm signal) (the inspection tour of the login information such as presence of abnormal signal. 6, in an emergency, oil-immersed natural cooling and air cooling transformer allow short-time overload operation, environment temperature below 20 degrees and, allow the load (30%), environmental temperature 30 degrees, allow the load (15%). But the overload runs no longer than (24) hours. 7, voltage than different and impedance voltage transformer in any one will not overload, can run parallel, but voltage contrast values should not be more than (1%), the impedance voltage difference should not be more than (10%), capacity than should not be more than (1/3), different transformer connection group is strictly prohibited in parallel, different impedance voltage transformer should be appropriately raise the impedance voltage of the large transformer secondary volta