家装施工（Home decoration construction）.docVIP

家装施工（Home decoration construction） 1. Wall tile tiling process: 1; The foundation of the wall ground is inspected thoroughly, empty drum, pull wool, waterproof, water and water, ground leakage, the part that is unqualified to be dealt with is in place, then compasses square, put horizontal line. Fix the position of the switch and the socket in each position. 2; Wall, floor tile should be suitable indoor temperature, want to row brick, choose brick, full water after spread the post. 3; Use 32.5 cement, medium sand. Ratio: 1:2.5, ground 1:3. Shop floor tile dry brooming to the ground, and using 1:4 concrete, humidity with palm can disperse clouds thrown on the ground, smooth, will try the floor tile shop, back buttering sequence in turn after the shop is stuck. 4. The Angle of the yangjiao all USES 45 degrees clear Angle, wall brick wants to be to the grain, pair of color, aperture 2 millimeter, horizontal horizontal vertical, brick seam should fill with seaming agent fill, roll solid. 5; Floor tile to wall pressure, wall tile joints and floor tile at least two faces straight. The slope of floor drain and ground is 1%. 6; The floor tile is not obvious to the color difference of 2 meters, the air drum rate is less than 5%, the flatness 2 meters is less than 3mm, and the brick seam is 2mm horizontal and vertical. Ii. Coating process of wall and top surface: 1; To metope thoroughly empty drum, crack detection, part of empty drum, with grassroots gypsum powder filling level off, do Rio seam filling cracks, the revised parts do stick kraft paper, cloth cloth with stickers. 2; On top of the wall flat, Yin and Yang Angle make vertical processing, after full brush interface agent, local leveling, the light body wall, insulation wall to do post processing, kraft paper in waterproof putty three times, be bored with child stir evenly with electric tools. 3; The fine sandpaper is polished, the float is removed, the roller is painted, and the sides are painted on both sides. The w