弹簧管式精密压力表及真空表检定规程（The spring tube type precision pressure gauge and vacuum gauge calibration procedure）.docVIP

弹簧管式精密压力表及真空表检定规程（The spring tube type precision pressure gauge and vacuum gauge calibration procedure） The information that is worth having It comes from the accumulation of learning There must be a problem Also please criticize the correct! The spring tube type precision pressure gauge and vacuum gauge calibration procedure JJG 49-87 replaces JJG 49-72 Verification Regulation of the Precise Bourdon Pressure Gauge and Vacuum Gauge This verification procedure was approved by the national bureau of metrology on 11 April 1987 Effective from 1 October 1987 Unit: Shanghai standard measurement bureau Drafting unit: metrology management institute of Shanghai standard metrology authority The technical provisions of this procedure shall be interpreted by the drafting unit The main drafters of this discipline: Xuanjiong (metrology management office of Shanghai municipal standard measurement authority) The spring tube type precision pressure gauge and vacuum gauge calibration procedure This procedure is applicable to the test of a spring-tube type precision pressure gauge and a vacuum gauge (hereinafter referred to as an precision table) for new manufacturing, use and repair, with a maximum of 0.1 ~ 250MPa Technical requirements 1. The distance between the precision table pointer (including the replaced pointer) and the dial plane shall be within 0.5 ~ 1.5mm range. Its blade is perpendicular to the dial plane Pointer indicator should be extended into the shortest dividing line 1/4 ~ 3/4 Indicates that the blade width should not be greater than the dividing line width 2 precision watch dial and surface glass should not interfere with reading defects and damage The zero value of the table dial must not be fitted with a limit pin The dial width should not be greater than 0.2 mm The precise table of 3000 points should be evenly spaced The outer arc length of the graduated scale should be in accordance with table 1 Table 1 The movement of precision table pointer should be stable