电缆试验项目（Cable test item）.docVIP

电缆试验项目（Cable test item） Electric power cable test project 2009-11-30 15:01:15 | classification: electrical engineering | label: | font size small and medium size subscription. 18.0.1 power cable test items, including the following: 1. Measuring insulation resistance; 2 dc withstand voltage test and leakage current measurement; 3. Ac withstand pressure test; 4. Measuring resistance of metal shielding layer and conductor resistance ratio; Check the phase of the cable line at both ends; Test of insulation oil for oil cables; Cross interconnection system test. Note: 1 rubber and plastic insulation power cable test items shall be carried out in accordance with section 1, 3, 4, 5 and 7 of this article. When the condition is not available, the rated voltage U0 / U is 18/30kv and the following cable, which allows for the use of dc pressure test and leakage current measurement instead of ac pressure test. 2 paper insulation cable test items shall be carried out in accordance with section 1, 2 and 5 of this article; 3 self-capacitance filling cable test items shall be carried out in accordance with section 1, 2, 5, 6 and 7 of this article; 18.0.2 power cables shall be tested in accordance with the following provisions: 1. When the main insulation of the cable is tested or the insulation resistance is measured, it shall be carried out separately in each phase. The other two phase conductors, metal shielding or metal sleeve and armor layer shall be grounded together for the test or measurement of a phase. 2 to foil or metal sleeve grounded at one end, another end is equipped with covering over-voltage protector for the single core cable main insulation withstand voltage test, covering over-voltage protector for short answer, must be make the end of the cable metal shielding temporary grounding or metal sleeve; A 2500V megabytes measuring conductor with a voltage of 0.6/1kv was used to measure the resistance of the conductor to the ground insulation resistance, and the test time