给排水之水池（Water supply and drainage pool）.docVIP

给排水之水池（Water supply and drainage pool） Water supply and drainage engineering structure design specification chapter iii pool Section 1 general provisions Article 3.1.1 the structural design of a pool shall meet the following requirements: One, all kinds of structure type, form pool should undertake intensity computation. According to the load conditions, engineering geology and hydrogeological conditions, the necessary fashion should check structural stability. Two, reinforced concrete cistern should undergo crack or crack width checking. In the case of load, the section of the member of the component should be subjected to the stress state of the axial tension or small eccentricity. During the use of the load, the section of the member is subjected to bending, eccentricity compression or large eccentric tension, and the crack width should be checked. The prestressed concrete cistern should be calculated in terms of crack resistance. Article 3.1.a combination of the strength of the underground type or the strength of the ground water pools with insulation facilities shall meet the following requirements: The load combination of a closed water test includes structural self-gravity and water pressure in the pool. Two, the load combination of the use phase: 1. Structural self-weight, live load, full water pressure in the pool, pressure of external water pressure and soil pressure; 2. Structural self-weight, live load, water pressure and soil pressure. Article 3.1.3 the strength calculation load combination of the ground water tank without thermal insulation facilities shall meet the following requirements: First, the structure self-gravity and the water pressure in the pool. 2. Structural self-weight, live load, full water pressure and temperature load. Note: the bottom plate can not be used for temperature load; The temperature load includes two items: the temperature difference of the wall surface and the humidity equivalent. The temperature difference should not be