车床考试知识（Lathe test knowledge）.docVIP

车床考试知识（Lathe test knowledge） The longitudinal feed and transverse feed of the lathe (B) are helical transmission. A light bar B, slide plate C, spindle D, rotation The activity sleeve of the micrometer ruler is rotated and the micrometer screw is moved (C). A, 1 mm B, 0.1 mm C, 0.01 mm D, 0.001 mm 102. When measuring with a percentage, the measuring rod should be compressed by 0.3-1mm in advance to ensure that there is some initial test force, so that (D) cannot be detected. A size B, tolerance C, shape tolerance D, negative deviation 103. Before starting work, it is necessary to wear protective equipment according to the regulations (B). A, important provisions B, general knowledge C, rules D, system 104. When the bits are wound with iron, they should be stopped in time and cleaned with (C). A hand B, workpiece C, hook D, mouth blow 105. The drill bit (D) is zero. The friction between the edge of the cutting part and the hole wall is more serious, and it is easy to heat and wear. A front Angle B, rear Angle C, slope D, and rear Angle The accuracy of the hole is high and the surface roughness value is required for an hour, and the cutting fluid mainly used (A) should be selected. A lubricating B, cooling C, flushing D, anti-corrosion (1) the penalty for the failure of the time of attendance and the severity of the examination and alteration of the attendance at the time of examination is punishable by A fine of A. 100 yuan b. 50 yuan c. 150 yuan d. 200 yuan (1) to do private work at work time, and to be fined by the Internet for non-work. A. 50 b. C. 100. 150 D, 200 109. During the companys meeting, the participants were transferred to vibration or shutdown, and the offenders were fined _____ yuan; A. b. 10 20 c. d. 50, 100 (B) after a fine of education, the person who still does not corrects shall be given a punishment. A. economy b. administration c. warning d. oral 111. (C) to throw cigarette butts and garbage in the public area with a fine of ________yuan; A. b.