钳工实训大纲（The training program of the fitter）.docVIP

钳工实训大纲（The training program of the fitter） The training program of the fitter This article is contributed by xx188840812 The training program of the fitter 1. The purpose of practical training is to enable students to understand commonly used marking tools and to conduct basic operation training. 2. Practical training requires (1) proper use of the marking tool. (2) master the method of cleaning and marking the surface of the workpiece. (3) master the basic operation method of the horizontal line, make the line clear and uniform, and the dimensional error is not greater than or minus 0.30mm. (4) correctly read the steel ruler scale. Tools and materials tools: steel ruler, scriber, compass, spout, hammer, etc. Material: Q235 thin plate, the specification is 200mm x 300mm. 4. The actual training contents (1) the workpiece pattern (see figure 1) (2) step and method to check the blank materials and the appearance size of the workpiece, and properly lay the workpiece and tools. Understand the pattern and arrange the position according to the size of the drawing. Reasonable selection of paint, and a uniform coating on the surface. To select the underlined criteria correctly, underline the steps of geometry. Check all the graphic dimensions and make sure that the sample size is correct. Before you underline (1), remove the burr from the workpiece and remove the dirt and prevent the scratches. (2) make a paper exercise before the actual operation. (3) the focus of the training is to ensure the accuracy of the marking and the accuracy of the sample punching. (4) the tools should be properly placed. (5) after the work of the workpiece is finished, the review should be carefully reviewed to avoid mistakes. Figure 1 [project 2] saw cutting steel item 2. The purpose of practical training is to familiarize students with the use of hand saws and to cut off simple workpieces. 2. The actual training requires (1) the saw blade is installed properly and the cutting position is correc