鼓式制动器（Drum brake）.docVIP

鼓式制动器（Drum brake） Drum brake maintenance data database Shanghai general braking system Drum brake 1. Specifications 2. Maintenance 3. Description A, specification 1. Parts specifications Application specification Wheel cylinder piston diameter 19.05 mm The width of the drum is 28 mm Drum diameter (new) 200 mm The diameter of the drum is 201 mm Allowable maximum eccentricity of 0.1 mm Brake friction lining thickness (with rivets) 0.5mm 2. Tightening torque Application specification The rear brake floor bolt is 50 newtons Wheel cylinder bolts 9 Newton meters The brake pipe that is connected to the wheel cylinder is 16 newtons Exhaust valve 6 Newton meters Anti-lock braking system tail sensor bolt 4 newtons Second, the maintenance Check the brake lining · check brake lining for every 15,000 kilometers. · check the brake lining when removing the wheel (tire replacement, etc.). · remove the rubber plug in the hole of the brake lining. · check the thickness of the brake friction liner 2 mm. Whenever the brake friction lining is worn down to 2mm, the drum brake friction lining is changed. If it is a brake lining with a riveted rivet, replace the lining when the liner is worn to 0.5mm of the rivet head. The drum brake friction lining is replaced by shaft sleeve. · install the rubber plug of the observation hole. 2. The replacement of brake lining (1) remove 1) lift up and properly support the vehicle. 2) mark the position of the wheel relative to the hub. 3) remove the wheel and tire. 4) remove the brake drum. Remove the car brake line from the pull of the bar. 6) remove the top pullback liner (remove with spring clamp), as shown in figure 5-7. 7) remove the back spring and spring bracket with a screwdriver. 8) remove the adjusting slider, as shown in figure 5-8. 9) remove the compression spring wafer, spring and its fixed pin with KM - 346 tool. Remove brake drum. 11) be sure to replace all brake friction linings on a shaft. (2) to install 1) install brake floor surfa