2春季学校工作计划[].doc

第八中心小学 2013年春季学校工作计划 一、指导思想 以党的十八大精神为指导，用“科学发展观”统领学校全局工作，学校管理，深化课，优化课堂教法，加强校园安全纪律教育与校园文化建设，将素质教育理念和德育教育落实到学校工作的每一个环节中。全面营造的育人环境，办人民满意的教育。逐步实现开放式办学。开辟有效途径，通过家长委员会家长参与学校管理和监督。利用“校长信箱开放”等方式，增强社会评校、家长评师权能，广泛听取校内外的意见和建议，不断推进学校的管理工作。1、安全工作坚持“预防为主、标本兼治”的原则,认真落实各项措施，定期、创建节约型校园维护好、使用好办公用具， the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the feeler gauge measurement of gauge blocks or finishing. bearing surface, markup should be in accordance with the mounting support pads, and retest the thickness. Once the lifting cylinder measurement of surface and internal cylinder surface height difference, compared with the origin