2009年二级建筑师市政工程模拟卷部分题与答案（In 2009, the secondary architect municipal engineering simulation volume part and the answer）.doc

2009年二级建筑师市政工程模拟卷部分题与答案（In 2009, the secondary architect municipal engineering simulation volume part and the answer） In 2009, the second class builder municipal engineering simulation volume part and the answer 1. Single topic selection (total 20, 1 point for each question). Only 1 of the candidates in each question are most suitable for the topic. Scene (1) The road structure of the main road of a city is: the road foundation is filled in, the soil height is 2-3m. The road surface is 150mm of base base of 12% limestone soil, 150mm lime fly ash gravel base, asphalt concrete surface layer (coarse grain type 60mm, medium grain 40mm thick), total 100mm, a total of 410mm. Due to the impact of demolition, pavement engineering needs to be organized in winter. According to the scene (1), please answer the following questions: 1. Any compacting mechanical ground subgrade shall be compacted in the optimal water content of the soil. A1 % B2 % C1.5 % D2.5 % Answer: B Analysis: water stability is the best in the best water content. 2. The upper layer of urban trunk road and expressway will need to pass () test to test the rutting ability. A Marshall test B high temperature rut test C. Oil-stone ratio test D residue test Answer: B Resolution: 3. Regarding the construction process requirements of asphalt mixtures, the following statement is wrong () The maximum size of the aggregate of asphalt concrete is gradually increased from top to bottom, and the maximum particle size of asphalt mixture is not more than 1/2 of the thickness. B important asphalt concrete pavement should be built 100-200m test section, mainly divided and test in two stages, obtain corresponding parameters. After the construction of hot mixed asphalt mixture, the surface temperature is lower than 600C before the vehicle can be allowed to pass. D hot mix asphalt mixture of two adjacent spokes and upper and lower horizontal joints construction should be staggered more than 1m. Answer: C Analysis: when the surfa