500程控（500 program-controlled）.docVIP

500程控（500 program-controlled） ERR1: Power fluctuation range exceeds regulation (over Seper) 1, external power supply voltage fluctuation range does exceed Seper Workaround: Shan asked users to seek help from local power supply units, such as the Electricity Supply Bureau. Shan users to invest in the regulator, if the external power supply although the fluctuation range of more than Seper, but more stable, can buy enough capacity of the voltage regulator. In the use of voltage regulator, must be installed in the exposure process regulator adjustment lock circuit, otherwise it will cause the console and voltage regulator damage. 2, power supply board (1th plate), Power sampling value range (DC11V) Solution: Detecting the voltage value between the resistor R1 and the potentiometer R2 in the power supply panel is not satisfied by the DC 11v, then the R2 is satisfied by adjusting the potentiometer: Vivi into S.380 X 10 (v into the current measured network voltage) 3, power supply board (1th plate) in the power sampling point (between R1 and R2 position) before the circuit failure Solution: Check the resistor R1 and potentiometers before the R2 circuit of the components, for example, Transformer T1, Silicon bridge V1, insurance tube F1, diode V2 and so on. Replace the damaged components. 4, power supply board (No. 1th plate) Peater 15v power failure Workaround: Check if the TP10 point voltage in the power supply board is normal (15V. 2v. 1V). When the voltage is too low, it may be a short-circuit phenomenon inside the machine, or LM338 (LM7815) damage, repair or replacement. 5, power supply board (1th plate) device D1, D2, V7, V8 work abnormal Solution: Check the work voltage of D1, D2, V7, V8, judge the abnormal work of the device, give the replacement. 6. The interface part of the power supply board (No. 1th plate) and the computer Board (8th Plate) is working abnormally Workaround: Shan Check the connector between the power supply board (No. 1th plate) and the computer