判断高级工（judge）.docVIP

判断高级工（judge） A senior workers 1. () in the process of polymerization, the temperature rose to 40 ℃, the PP is generated. Answer:) 2. () the heat transfer of polymerization is mainly conduction and convection. Answer:) 3. () normally, no matter the tube or shell, when the fluid is heated, the flow should flow from the bottom up, when the flow is cooled, the flow should flow from top to bottom. A: x The heat of reaction of the polymerization kettle is to heat the heat by clamping water and inner cold water. Answer:) 5. () in the polymerization reaction H2 can participate in 100%. A: x 6. () single consumption refers to the ratio of output to the amount of material produced minus the amount of return. A: x 7. The higher the pressure, the better the pressure. A: x 8. () propylene can be replaced by the propylene tank during the first commencement of construction. A: x () the safety valve and the lead seal indicate that the test pressure is in good condition and can be used. Answer:) 10. The vacuum pump used in the flash steam position is a water ring vacuum pump. Answer:) 11. The action of the flash vaporization is to prevent the polymerization spray from cooling the powder. A: x 12. () when entering the container operation, the valve on the container can be entered as long as it is kept tight without a blinding plate. A: x 13. The motor power used in the polymerization kettle is 55 kilowatts. A: x 14. () in the composition of polypropylene powder, the active agent has the highest impact. Answer:) 15. () the activator system must be replaced with pure nitrogen in the commencement of construction. Answer:) The lubrication of vacuum pump is a bearing box and should be added to the zl-3 lithium base. Answer:) 17. In the same case, the number of vacuum displacements of flash vapors can be added to reduce the chlorine content in PP products. Answer:) 18. The substance that is adsorbed is called adsorbent. A: x 19. Product quality is a comprehensive reflection of quality char