三菱电梯检修实例(Mitsubishi elevator maintenance instance).doc

三菱电梯检修实例(Mitsubishi elevator maintenance instance).doc

  1. 1、本文档共14页,可阅读全部内容。
  2. 2、原创力文档(book118)网站文档一经付费(服务费),不意味着购买了该文档的版权,仅供个人/单位学习、研究之用,不得用于商业用途,未经授权,严禁复制、发行、汇编、翻译或者网络传播等,侵权必究。
  3. 3、本站所有内容均由合作方或网友上传,本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺!文档内容仅供研究参考,付费前请自行鉴别。如您付费,意味着您自己接受本站规则且自行承担风险,本站不退款、不进行额外附加服务;查看《如何避免下载的几个坑》。如果您已付费下载过本站文档,您可以点击 这里二次下载
  4. 4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等,请点击“版权申诉”(推荐),也可以打举报电话:400-050-0827(电话支持时间:9:00-18:30)。
查看更多
三菱电梯检修实例(Mitsubishi elevator maintenance instance)

三菱电梯检修实例(Mitsubishi elevator maintenance instance) MITSUBISHI elevator GPS fault elevator maintenance examples share: 124.14.228.*, 1 floor Case analysis of elevator fault 01 Fault phenomenon: A hospital two MITSUBISHI GPS-I elevator, when there is a call, in an elevator group control in response to the call, the call is not disannul, only another elevator also in response to the call, just eliminate no.. That is to say, for any outside call, two group control elevators should respond once. Treatment process: 1. check the floor settings, single staircase / group control settings in the elevator software, and find no problems; 2. check outside call connection and correct wiring. 3. disconnect the power supply of the group control cabinet, and then disconnect the main power supply of one of the elevators, then another elevator works normally. 4. disconnect the group control panel power supply, and respond to any call or two elevators. 5., through the above test, it can be concluded that the independent operation of the two elevators is normal, the problem should be in the group control part, or the communication between the group control and the individual ladder; 6. check and change (or replace) the group control computer board, without any problems; 7. when inspecting the fiber optic cable, it is found that the two parts of the optical fiber are respectively bundled on the frame of the control cabinet, and the radian of the bent part is too small. Replace two optical fiber communication cables, and lift back to normal. This case inspires: In this case, two elevators share an outside calling signal, that is, the calling signal is a set of buttons and two sets of display forms. The outside calling signals are respectively communicated with the group control computer board after entering the P1 main computer board of the two elevator, and then passing through the fiber optic cable. When the communication fails, the two elevators are in a separate state of operation. Al

您可能关注的文档

文档评论(0)

f8r9t5c + 关注
实名认证
内容提供者

该用户很懒,什么也没介绍

版权声明书
用户编号:8000054077000003

1亿VIP精品文档

相关文档