2012年秋大连理工《房屋建筑学》作业2及答案2（In the fall of 2012, dalian institute of technology housing architecture homework 2 and answer 2）.doc

2012年秋大连理工《房屋建筑学》作业2及答案2（In the fall of 2012, dalian institute of technology housing architecture homework 2 and answer 2） I. radio questions 1. the slab without beam floor should be arranged in square grid as far as possible. When the floor live load (kg/m2) and span is about (or), the economy is greater than the beam slab floor, and the slab thickness should be more than 120mm due to the large span of the slab. A. = 500, 5m B. = 500, 6M C. 600, 6M D. 600, 5m 2. in order to prevent the overflow of indoor water, the floor or ground elevation of a water room should be lower than that of other rooms or corridors. A. 10~20mm B. 20~30mm C. 30~40mm D. 40~50mm The level of moisture layer in 3. plinth design often in elevation (said). A. + 0 B. -0.06m C. -0.01m D. -0.04m The level of moisture-proof layer should be set up in the 4. plinth from the ground outside (mm) above the plinth masonry, to prevent the effects of surface water of reverse osmosis. A. 120 B. 140 C. 150 D. 180 (5.) general without limit span beam. A. reinforced brick lintel B. reinforced concrete lintel C. brick flat arch D. brick round arch 6., because of the nature of the building and the conditions used, the environment is different, the building structure design has different requirements. For example, the northern areas require buildings (); the South requires building (). A. can ventilate and heat insulation, and can keep warm in winter B. consider sound absorption and sound insulation, and consider cold protection and warmth retention C. can keep cold and warm in winter, waterproof, moisture-proof, sound absorption and sound insulation D. is insulated in winter and ventilated and insulated 7. the structural layer of the floor is usually made of (concrete) concrete. A. C5 B. C10 C. C15 D. C20 The width of 8. reinforced concrete beam with the same wall thickness, the height is generally not less than (mm). A. 100 B. 240 C. 180 D. 120 9. in buildings, transverse walls are generally referred to as ()