LED安规资料（LED safety data）.docVIP

LED安规资料（LED safety data） This article is contributed by yetaiye DOC documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. In recent years, as a result of global warming and energy issues, energy saving has become the most urgent problem facing all countries in the world. It has led to the rapid development of lighting products using LED as a light source. All kinds of lamps or the original use of traditional light sources, such as incandescent light bulbs and halogen lamp / lamp, although there are gradually replaced by LED potential, but because the current is still unable to effectively reduce the cost of conversion, so instead of comprehensive is still a long way to go. At present, LED lighting related products can be divided into LED lamps, LED light source power supply module and LED energy-saving lamp three categories, applicable European and international safety standards as listed below: power LED lamp LED light source module supply LED energy saving lamp IEC/EN 60598-1 IEC /EN 61347-1 General requirements IEC/EN 62031 individual standard IEC/EN 60598-2 series (according to the installation and use of lamps or special distinction) IEC/EN 61347-2-13? E27 or B22d lamp caps: IEC/EN 60968? The other lamp cap category: IEC/EN 60061-1 + IEC/EN 60061-3 IEC/EN 62031 is a new standard LED light source module, the applicable range for all types of LED module as the light source used, no matter the LED module contains or does not contain the power supply line can be applied. When the LED module contains the power supply line, it applies an input voltage of alternating current below 1000 volts, a frequency of 50 Hz or 60Hz, or 250 volts of direct current. Generally speaking, the standard to do European regulation is as follows: 60598-1/-2, 62031, 60968, 62471, etc., for the control circuit part, there will be 61347-1/-2. Specification for safety of LED lamps on the LED light so