二极管和三极管（Diode and triode）.docVIP

二极管和三极管（Diode and triode） Diodes and triode diodes 1. Single topic: 9. Output impedance () of the emitter output device, often used in the output pole. A: high B: low C: not high or low D: high 10. Dc voltage at both ends of the diode half wave rectifier is equal to (). A: 0.75 U2 B: U2 C: 0.45 U2 D: 0.9 U2 12. The voltage magnification of the emitter is approximately equal to (). A: 80 -- 100 B: 1 C: 50 D: 20. In the amplifier circuit, in order to stabilize the output current, the () should be introduced. A: voltage negative feedback B: voltage positive feedback C: current negative feedback D: current positive feedback 22. In a triode amplifier circuit, an amplifier circuit is used to enhance the load carrying capacity. A: common emitter B: common base C: common collector D: common cathode 24. The potential of the three tube feet in the amplified circuit is (1) 0V. (2) 0.7 V; (3) 6V, the triode is () type. A: NPN B: PNP C: silicon tube D: germanium tube It is () that the amplification of the amplifier USES the electrode offset improvement. A: current positive feedback B: current negative feedback C: voltage positive feedback D: voltage negative feedback 33. The transistor of the transistor is placed in a bias, the collector junction is in bias, and the transistor is in () working state. A: enlarge B: cutoff C: saturated D: open road 34. The junction of the transistor in the transistor is at a positive bias, and the working state of the triode is (). A: saturation B: cutoff C: enlarge D: guide 39. The transistor of the transistor is in a magnifying working state, the collector potential is 6V, the base potential is 0.7v, and the emitter is grounded, the triode is (). A: NPN B: PNP C: N D: P 41. The role of a common emitter amplifier, collector resistance RC is (). A: electric current amplification B: the transistor current amplifies the transmission voltage amplification C: current amplification and voltage amplification D: stable working point 2. Multiple choice: