维修试题-1（Maintenance item - 1）.docVIP

维修试题-1（Maintenance item - 1） Maintenance questions - 1. The insane lunatic of TXT is not terrible, the terrible is the sane lunatic! 1. In actual work, the most commonly used measuring instruments include vernier calipers, micrometer calipers, micrometer caliper, dial gauge, micrometer, height vernier, block gauge, and percentage of internal diameter. The line of marking is: the underlined plate, the compass, the scriber, the scriber, the scriber, the straight Angle, the sample. The work of the fitter includes: marking, chipping, sawing, filing, drilling, reaming, tapping, scraping and grinding. According to the precision of the scraping workpiece, the scraping can be divided into three steps: rough, thin and fine. 5. In grinding, the abrasive cutting process of the workpiece with a multi-blade blade is applied to the workpiece, which includes both physics and chemistry. 6, manual grinding trajectory generally USES the straight line, cycloid, spiral and imitation of figure 8 kinds, no matter which kind of lapping movement trajectory, their common characteristic is processed surface of the workpiece and the plate work faces or parallel motion. 7. According to the characteristics of the file, the file can be divided into single tooth pattern file, double tooth cut file, coarse tooth file, fine tooth file, etc The drill used for drilling is mainly composed of hilt, neck and working part. 9. The rolling bearing, codenamed 302, whose inner diameter is 15mm, is the bearing of 210, and its inner diameter is 50mm. 10. The medium and low pressure flange sealing face structure has a flat seal, concave and convex surface seal, and tenon groove sealing. 11. The measurement of the width of the keyway is generally suitable for using the vernier caliper. 12. When the equipment is repaired, the repair of the surface of the worn parts usually has multiple welding, plating, bonding and spraying. The effect of grinding is to obtain high surface finish, dimensional accuracy, geometric