CAD教程第八章（CAD tutorial 8）.docVIP

CAD教程第八章（CAD tutorial 8） This paper consists of 570460319 contributions Ppt documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. Eighth chapters Draw a smiley face Teaching requirements in this chapter Grasp the circle command, master the method of changing the length of the line and the arc, master the method of the equal figure, and master the method of drawing the measuring point Sign out 8.1 knowledge points in this chapter in 8.2 cases: draw a smiley face drawing drawing tui cases: 8.1 chapter knowledge points 8.1 draw ring to enter the command: drop-down menu: enter the command: Draw\ Draw\Donut Command:Command:Donut Specify inside drop-down menu: diameter of donut default :donut default default value Specify outside diameter of donut :donut default default default value Specify center of donut or exit:exit: the ring line is filled by the system variables control FILLMODE FILLMODE control AutoCAD the. Control. The length of the input command 8.1.2 change of straight line and arc: drop-down menu: Modify\Lengthen drop-down menu to enter the command: Modify\ tools: Tools: Modify, Lengthen Command:Command:Lengthen Select an object or [DElta/Percent/Total/ Dynamic]:Dynamic]: (1) in the Select an object or [DElta/Percent/Total/ Dynamic]: prompt to change the length of the selected graphic Dynamic]: prompt selection to change the length of the graph is selected to change the length of the graphics, AutoCAD display shows the current parameters of the selected graphic current parameter AutoCAD selected graphic display long: line displays the current selected graphic parameters: Degree (Current: length); circular arc length and central angle display: length display); circular arc length and central angle: length); included, angle:: ). ). And then go back (Current length: included, angle:). Then go back to the original hint. Go to the original prompt. (2) in the Select an obj