dtm土方计算（DTM earthwork calculation）.docVIP

dtm土方计算（DTM earthwork calculation） User recommended answer DTM method earthwork calculation By the DTM model to calculate the earthwork volume is measured according to the coordinates of ground points (X, Y, Z) and the design elevation, by generating triangulation to calculate the amount of earthwork every three pyramid, finally accumulated earthwork specified within the scope of cut and fill, and draw the demarcation line of earthwork. There are two methods of earthwork calculation in DTM method. One is complete calculation, and the other is calculated according to the triangulation network on the drawing. Complete calculation method contains the process re establishment of triangulation, is divided into according to the coordinate calculation and calculation according to the elevation point map on the two methods; in accordance with the graph triangulation graph directly using the existing triangle, not rebuild triangulation. The operation of the three methods is described below: 1. according to coordinate calculation (1) draw the line with a composite line, and make sure the area is closed, but try not to fit it. Because the fitted curve is used in earthwork calculation, it will be affected by the line iteration, which will affect the accuracy of calculation results. (2) use the mouse point to take the DTM method earthwork calculation sub menu under the engineering application menu, according to the coordinate file. (3) hint: select the boundary line and draw the closed compound line with the mouse. (4) enter the boundary interpolation interval (m): the default value of the boundary interpolation interval is 20 meters. (5) the screen will pop-up pop-up coordinates file dialog box, in the dialog box to select the required coordinate file. (6) hint: flat field area = XXXX square meter: the horizontal projection area of polygon whose value is the composite line. Level elevation (m): enter design elevation. (7) enter the display on the screen of excavation and fillin