漏电保护器原理（Leakage protector principle）.docVIP

漏电保护器原理（Leakage protector principle） Leakage protector principle 2011, 06, 21, 16:53:38 Leakage protector principle If that is the single-phase grounding and grounding wire pole, do not enter the security device, live line zero line into the same core into a winding, if there is no leakage flux, the winding is zero, another winding the core control circuit does not work without output. When excess leakage occurs, the FireWire and zero lines can have flux that cannot be counteracted, and the electronic circuit cuts off the total power supply. If it is a three-phase leakage protector, the three-phase line and the zero line enter the magnetic core and become the winding. Three phase electricity must be unbalanced. At this point the zero line has current, but the vector sum of the flux produced by the four lines is equal to zero without leakage. If excess leakage is exceeded, the guard will act and cut off all the power supply of the three-phase. A leakage protector is three-phase three wire leakage breaker, at the same time through the zero sequence current transformer A, B, C three phase, any leakage, zero sequence transformer to detect the leakage current, after amplification the circuit breaker, the breaker can only be used for motor protection, and can not be used in single phase or three phase four line protection. (because the zero line does not pass through the zero sequence transformer, it will be considered as a leakage current when it is operated by an electric appliance) The utility model is composed of two sampling circuits, a comparison circuit and a control circuit. The principle is: according to a series circuit current everywhere equal theory, in the power of the firing line and the zero line are respectively provided with a sampling circuit and sampling data sent to the comparison circuit, if two current difference exceeds the set value, the circuit is that the leakage, immediately start control circuit to cut off the firing line and the zero line. To