螺纹转换（Thread transition）.docVIP

螺纹转换（Thread transition） Metric thread, thread, thread conversion Release time: 2010-8-18? Read frequency: 1567? Font size: [small] [big] NPT, PT, and G are pipe threads NPT is the abbreviation of National (American) Pipe Thread, belonging to the American Standard 60 degree taper pipe thread, used in North America. National standards can refer to GB/T12716-1991 PT is the abbreviation of Thread Pipe, is a 55 degree taper pipe thread sealing, belonging to the Whitworth family, for many European and Commonwealth countries. Often used for water and gas pipe industry, taper regulations of 1:16. national standard is available on the GB/T7306-2000 G is a 55 degree non thread sealing pipe thread, belonging to the family of Wyeth thread, marked G for cylinder threads. National standards refer to GB/T7307-2001 In addition, the 1/4, 1/2 and 1/8 marks in the thread refer to the diameter of the thread size, in inches My wife usually refers to the thread size by one point, one inch equals 8, and 1/4 inches is 2, so so G seems to be the pipe thread collectively (Guan), 55, 60 degrees division is functional, commonly known as tube round. The thread is machined from a cylindrical surface. ZG is a commonly known as cone, cone thread processing, pipe joint is generally the old GB marked Rc Metric threads are represented by pitch, and American and British threads are expressed in thread per inch. This is their greatest difference, Metric thread is 60 degrees equilateral tooth type, thread is isosceles tooth type thread 55 degrees, 60 degrees. Metric units for metric threads; British and American systems. Pipe thread is mainly used for pipe connection, the internal and external threads are closely matched with straight pipe and cone pipe two kinds. Nominal diameter refers to the diameter of the pipe to be connected. Obviously, the diameter of the thread is larger than the nominal diameter. 1/4, 1/2, 1/8 is the nominal diameter of inch inch, inch in inches. ? However, I am still a little