后张法简支箱梁预应力施工工艺（Prestressed construction technology of simply supported box girder with post tensioning method）.docVIP

后张法简支箱梁预应力施工工艺（Prestressed construction technology of simply supported box girder with post tensioning method） Prestressed construction technology of simply supported box girder with post tensioning method China Railway nineteen Bureau Group Fifth Engineering Co., Ltd. Xinxiang beam field Key words: three control, strength, modulus, age, control stress, tensile force, cycle test, regular calibration, check before use Abstract: post tensioned prestressed box girder construction, the required tensioning machine comprises an oil pump, Jack, 0.25 shock oil pressure gauge of raw materials by 1 * 7-15.2-1860MP a low relaxation steel strand. In accordance with the construction process of prestressed construction, pull rod, hole cleaning, steel strand processing, steel strand transmission and so on. Pre stress according to the pre tension, initial tension and final tension in three stages, the tension before the three control: the beam of concrete reaches 35.5MPa, can be pre tensioned; strength to meet the design requirements of the 43.5MPa, can be the beginning of tension, according to the site, pre and early tension can be carried out at the same time, and, at the beginning of a pre Lajun die tensioned, the tension before the end of the beam; reached 53.5MPa in concrete strength, elastic modulus reached 35.5GPa, age greater than 10 days for the final tension; tension process, prestress value of oil pressure data, elongation value as a supplement, and to achieve three concentric, two synchronization. Prestressed equipment to do: Periodic verification (jack used more than 1 months or 200 times), periodic calibration (pressure gauge by collision or oil leakage, oil table pointer cannot be returned to zero) and before the review before the tension, determined (oil pressure gauge and Jack is correct, the empty; Jack pull 2-3, sure Jack and hydraulic pipe work) to ensure the construction process, the equipment can work normally. When the tensioning is done, a guard plate and a