建模总结（Modeling summary）.docVIP

建模总结（Modeling summary） A little knowledge of the reinforcement calculation when: 1, in reinforced software (A), with a steel, with (B) said two grade steel, with three steel (C) said, with (D) said the new three grade steel (L) said, with cold rolled ribbed steel bar, with cold rolled twisted steel (N) said 2, the engineering seismic grade is composed of (fortification), (type), (high eaves) decision. 3, seismic grade on the calculation of steel (anchor), (overlap), (encryption area) three aspects of influence. 4, 10 in the computational setting can be reinforced on the (Computational setting), (node set), setting, setting, stirrup stirrup lap formula five aspects need to be adjusted according to the actual engineering project, 5, beam (column), plate bearing is bearing is (beam), is based on the (basis) for the column support. (a) three preparations before drawing: 1, drawing: the drawings are divided into: general description, foundation, column, wall and column reinforcement, beam reinforcement, beam reinforcement, reinforcement, layout, structure (sporadic stairs node nine parts, etc.) of the members 9, this part is independent. 2, analysis of drawing sequence: firstly, according to the general description of the project, based on the first component drawing, then the skirt part of the frame column can use column table function. Then make the wall and the edge reinforcement, because the wall will be the support of the beam. Then it is a coupling beam, because the coupling beam is the support of the secondary beam, so the coupling beam is placed in front of the beam. Then there is the main beam and the secondary beam. After drawing the above component, the plate and the plate reinforcement are very convenient, and the drawing board can be finished quickly by using the point drawing method or the automatic generation of the minimum plate, and then the reinforcing bar is matched with the plate. Finally count the stairs and so on. 3, the establishment of floor relat