当电脑不能自检 主机不能正常启动问题集---经验谈[精华]（When the computer fails to check itself, the host doesnt start the problem set - experience）.docVIP

当电脑不能自检 主机不能正常启动问题集---经验谈[精华]（When the computer fails to check itself, the host doesnt start the problem set - experience） When the computer cannot be self-test, the host does not start the problem set properly 1, Power switch failure When the power switch button because the aging can not be reset or chassis front panel because of deformation caused by the power switch button can not be reset in time, using the switch is always in the state, then the power switch will appear, the main engine after the start, but after 4 seconds automatically shutdown. If the power switch related lines appear short, when we connect the host power plug, the host will power-up, 4 seconds after the automatic shutdown. Check the method for the boot and the motherboard pw_on interface connected to the panel switch, directly with the small screwdriver short jumper, to see if the host is also 4 seconds shutdown failure. If the failure disappears, you can conclude that there is a problem with the switching circuit. 2. Reset switch or jumper shorted Although the chance of such a failure is not much, but with the increase of computer use time, the reset key using the non-lock button switch will be due to the elasticity of the failure to appear after the press can not play, cause always connected status, or because the button installed on the front panel of the chassis is not in place or deformation, resulting in reset switch button can not be reset in time, long time in the state; again, because we repair process, pull, unplug inadvertently caused by the reset line short connection. At this point, when we press the power switch, because the motherboard is always in the reset state, although the mains have been plugged in, the CPU fan and Power fan, the video card fan, the motherboard fan has started to work, but the host does not have any boot trace. If we have the debug card inserted into the PCI slot, we will immediately find that the reset light is always bright, you can immediately determi