凸轮压力角：.DOC

凸輪壓力角： 1.滾子式從動件 2.平面式從動件 壓力角 = 00，但存在Overturning Moment(翻轉力矩)的問題，要使翻轉力矩小，則d 的值要儘量小,因而影響到設計凸輪的大小 凸輪輪廓曲率半徑： 滾子式從動件 平面式從動件 The center of curvature C is atationary on the cam that the magnitudes of c andρ, and angleα do not change for small changes in cam angleθ. (These values are not constant but at stationary values. Their first derivative with respect to θ are zero, but their higher derivatives are not zero) Differentiating eq.(8) with respect to θ, yields: