导线截面积与电流的关系（The relationship between conductor cross-sectional area and current）.docVIP

导线截面积与电流的关系（The relationship between conductor cross-sectional area and current） The relationship between the cross-sectional area of a conductor and the current is generally calculated by the method of copper wire safety: 2.5 square mm copper power line of the safe carrying capacity 28A. 4 square mm copper power line of the safe carrying capacity 35A. 6 square mm copper power line of the safe carrying capacity 48A. 10 square mm copper power line of the safe carrying capacity 65A. 16 square mm copper power line of the safe carrying capacity 91A. 25 square mm copper power line of the safe carrying capacity 120A. If it is aluminum wire, the line diameter should be 1.5-2 times of copper wire. If the copper line current is less than 28A, be sure to be safe at 10A per square millimeter. If the copper wire current is greater than 120A, it is taken at 5A per square millimeter. The current cross-sectional area of wire can be chosen according to the normal through the total current needed to conduct, can be determined according to the following doggerel: Ten five, two 25354 100, three, seven ten Jiuwuliang half, copper upgrade. Explain to you, is a 10 square aluminum square millimeter, multiplied by the number 5 on it, if it is a copper wire, lifting gear, such as the 2.5 square copper wire, is calculated according to 4 square meters. More than one hundred are multiplied by the cross-sectional area of 2, less than twenty-five square multiplied by 4, more than thirty-five square multiplied by 3, up seven and 95 square are multiplied by 2.5, so a few formulas should be easy to remember, Explanation: it can only be used as an estimate, not very accurate. In addition, if you remember to remember that wires are 6 square millimeters of copper wire, it is safe to say that the current per square meter is no more than 10A. From this point of view, you can choose 1.5 square copper wire or 2.5 square aluminum wire. 10 meters, the wire current density 6A/ mm is more appropriate, 10-50 m