satwe参数（SATWE parameter）.docVIP

satwe参数（SATWE parameter） SATWE calculation parameters detailed (2007-01-27, 13:59:32) categories: structural design learning experience I. General information: 1, the horizontal force and integral coordinate angle along different directions: earthquake, seismic reflect the size of the same, then there is a point of the structural seismic response value of the most unfavorable earthquake direction maximum. Design software can automatically calculate the maximum earthquake force direction and output in the calculations (see WQZ.OUT in the direction of maximum earthquake line), design personnel such as the origin of the absolute value of angle greater than 15 degrees, the numerical backfill to software horizontal force and whole body coordinate and angle option re calculated to influence reflects the most disadvantageous earthquake direction. 2, concrete bulk density: procedures default 25KN/m2, taking into account the impact of plastering, etc., we generally take 27KN/m2 here. 3, steel bulk density: procedures default 78KN/m2, if you consider the surface of the steel decorative layer weight, steel volume density can be filled in the appropriate value. 4, podium layers, layer number conversion: according to the specific circumstances of the input. 5 basement floors: must be accurate and complete, there are several main reasons, the calculation of wind load, the seismic effect of this parameter must be used, with this parameter, wind load and horizontal earthquake effect of the basement below will not pass down, but the vertical effect or pass down. The calculation of the side walls of the basement is also needed. This parameter is also used in the bottom reinforcement area. 6, wall subdivision maximum control length (unit m): the program defaults to 2, take the smaller, the more accurate. Values between 1.0~5.0, the program defaults to 2. For general engineering, the frame shear wall structure can be taken smaller, such as 1 or 1.5, without modifying this item. 7, the