- 1、原创力文档(book118)网站文档一经付费(服务费),不意味着购买了该文档的版权,仅供个人/单位学习、研究之用,不得用于商业用途,未经授权,严禁复制、发行、汇编、翻译或者网络传播等,侵权必究。。
- 2、本站所有内容均由合作方或网友上传,本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺!文档内容仅供研究参考,付费前请自行鉴别。如您付费,意味着您自己接受本站规则且自行承担风险,本站不退款、不进行额外附加服务;查看《如何避免下载的几个坑》。如果您已付费下载过本站文档,您可以点击 这里二次下载。
- 3、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等,请点击“版权申诉”(推荐),也可以打举报电话:400-050-0827(电话支持时间:9:00-18:30)。
- 4、该文档为VIP文档,如果想要下载,成为VIP会员后,下载免费。
- 5、成为VIP后,下载本文档将扣除1次下载权益。下载后,不支持退款、换文档。如有疑问请联系我们。
- 6、成为VIP后,您将拥有八大权益,权益包括:VIP文档下载权益、阅读免打扰、文档格式转换、高级专利检索、专属身份标志、高级客服、多端互通、版权登记。
- 7、VIP文档为合作方或网友上传,每下载1次, 网站将根据用户上传文档的质量评分、类型等,对文档贡献者给予高额补贴、流量扶持。如果你也想贡献VIP文档。上传文档
查看更多
溶胶-凝胶法制备rdxsio2膜 preparation of rdxsio2 film by sol-gel method
第32卷第2期 火炸药学报
20 0 of 17
9年4月 ChineseJournal
Explosives&.Propellants
溶胶一凝胶法制备RDX/Si02膜
吴志远,胡双启,张景林,王金英,姜夏冰,梁逸群
(中北大学化工与环境学院,山西太原030051)
摘 要:采用溶胶一凝胶法配制一定比例的Sioz溶胶。恒温(55‘C)陈放一定时间后形成凝胶,同时滴加RDX的丙酮
溶液,用玻璃基片提拉干燥得到RDX与Si02质量比为4;1的复合膜。讨论了温度和溶胶陈化时间对膜质犀的影
响。结果表明,在温度恒定并且黏结剂含量一定时,溶胶陈化时间短,所得薄膜厚度小,较平整,但黏性小,干燥后脆
裂;溶胶陈化时间较长时,所得薄膜厚度大,黏性大,但易结块;扫描电镜显示,RDX/sio:复合膜中RDX和SiO。分
布均匀。溶胶凝胶法制备RDX/Sio。复合膜中组分含量可调。在微型火工品中具有潜在应用价值。
关键词:应用化学;溶胶一凝胶法;RDX;炸药薄膜
中图分类号:TJ55;062 文献标志码:A 文章编号:1007—7812(2009)02—0017-04
of Film Method
PreparationRDX/Si02by
Sol-gel
WU
Zhi—yuan。HUShuang—qi,ZHANG Jin—ying,
Jing—lin,WANG
JIANG
Xia—bing,LIANGYi—qun
(Chemicaland SchoolofNorth of 030051,China)
IndustryEcology UniversityChina,Taiyuan
Abstract:Silicasolwas methodat molarratioandsilica formedatconstant
preparedbysol—gel specific gel
some whiletheacetonesolution
days dissolving dropped
temperature(55、C)throughageing hexogen(RDX)was
the whiteand ratiois4l filmwas
into RDX/Si02(mass
gelsystem.Thesub—transparent 1)compositeacquiredby
and substrateoutofthe after effectof and timeonthe
glass gel drying.Thetemperatureageing
dippingpulling
that andthe
filmwasdiscussed.Theresultsshow if
您可能关注的文档
- 曲线拉管在220kv电缆穿越河流中的应用.pdf
- 曲轴参数化建模及优化设计研究 research on apdl entity modeling and optimization design of crankshaft.pdf
- 曲线坐标系下考虑植被影响的三维水沙数学模型 a three-dimensional water-sediment turbulence model with the effect of vegetation in curvilinear coordinates.pdf
- 曲轴粗加工制造技术发展的一点启示 enlightenment from the development of crankshaft rough machining technique.pdf
- 曲轴系多学科行为耦合研究现状、讨论与展望 review of multidisciplinary coupling analysis for crankshaft system.pdf
- 曲轴轴承不同仿真模型的比较分析 comparison analysis of diverse simulation models for crankshaft bearings.pdf
- 曲轴强度疲劳计算的研究及应用 research and application of crankshaft strength and fatigue calculation.pdf
- 曲轴箱强制通风系统构成和发展趋势 structure of blow-by ventilation system and its development trend.pdf
- 曲线拟合法在工程机械发动机故障诊断中的应用 the application of curve fitting method in fault diagnosis of engine for construction machinery.pdf
- 去污泡沫粒径分析 elementary research for bubble size distribution in decontamination foam.pdf
- 溶胶凝胶法制备氮掺杂二氧化钛及其可见光活性的研究 study on preparation of nitrogen-doped titania by sol-gel technique and its visible light activity.pdf
- 日本震后大节电的效果与影响.pdf
- 溶胶-凝胶法制备的阻挡层对双层复合tio2光阳极性能的影响 effect of the blocking layer prepared by sol-gel method on the double composite tio2 photo-anode.pdf
- 溶液ph值对化学浴沉积cds薄膜性能的影响 the influence of ph value to the properities of cds thin film.pdf
- 溶液堆的应用及其核燃料处理 application and spent-fuel reprocessing of solution reactor.pdf
- 溶液除湿的地源热泵毛细管顶板空调系统 the capillary tube radiant ceiling panel air-conditioning system based on ground source heat pump and liquid desiccant.pdf
- 溶液堆物理计算程序fmcahr开发 development of fuel management code for aqueous homogeneous reactors.pdf
- 溶液蓄能制冷与压缩制冷复合循环工作特性分析 analysis for the characteristic of the working cycle combined the vmets system and the compression refrigeration system.pdf
- 溶液反应堆两相流动传热数值模拟 numerical simulation of both phases flowing heat transfer for solution reactor.pdf
- 溶气对不同燃油喷雾特性的影响 influence of dissolved gas on spray characteristics of different fuels.pdf
文档评论(0)