学车经验（Learning experience）.docVIP

学车经验（Learning experience） This article is contributed by zjbposen DOC documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. Learning experience 1. library moving down, the turning point for the middle rod, the steering wheel in place after the first round, the rear and the middle rod parallel to the rear wheel, the middle rod, the middle rod killed; two, the turning point for the first lever, the steering wheel in place after death; the first pole, the first pole with the car the middle position keep 30 cm distance, larger or smaller with the steering wheel to adjust; 2. a total of six discus discus discus 1, 2 when the position of the body right, discus in front of B, C, and about 30 cm from the front; 3 discus, turning point 3 discus intermediate point with the front glass and the middle point of alignment can turn (just put in place after turning a little bit late, discus 4, 6) turning point for the right wiper edge position (Kao Zuo) (to a little after turn again, more favorable turning point for the left 5) discus The mirror and the left edge of the left edge of the discus 5 wheel alignment, then killed (not to the turning point on each circle after steering) to see the edge cue point (aligned with the cue point point, not to tip the wiper) before, in advance right steering point: each has a discus in point. The turning point (car) and cue points (discus) after alignment (adjust the relationship between the two to 3. on the right) detour detour, the front position of B with the right on the left sideline detours away; when the detour, the front position of C with the left sideline to go detours; turn speed uniform. Can not be too fast, uniform; 4. rectangular bus (with the right to rely on the road, close to the right edge) when the front and front line is very close to the steering wheel quickly killed, turn, ready to cross the bridge; 5. The single plank bridge left