电压互感器的原理(The principle of voltage transformer).docVIP

电压互感器的原理(The principle of voltage transformer).doc

  1. 1、原创力文档(book118)网站文档一经付费(服务费),不意味着购买了该文档的版权,仅供个人/单位学习、研究之用,不得用于商业用途,未经授权,严禁复制、发行、汇编、翻译或者网络传播等,侵权必究。。
  2. 2、本站所有内容均由合作方或网友上传,本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺!文档内容仅供研究参考,付费前请自行鉴别。如您付费,意味着您自己接受本站规则且自行承担风险,本站不退款、不进行额外附加服务;查看《如何避免下载的几个坑》。如果您已付费下载过本站文档,您可以点击 这里二次下载
  3. 3、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等,请点击“版权申诉”(推荐),也可以打举报电话:400-050-0827(电话支持时间:9:00-18:30)。
  4. 4、该文档为VIP文档,如果想要下载,成为VIP会员后,下载免费。
  5. 5、成为VIP后,下载本文档将扣除1次下载权益。下载后,不支持退款、换文档。如有疑问请联系我们
  6. 6、成为VIP后,您将拥有八大权益,权益包括:VIP文档下载权益、阅读免打扰、文档格式转换、高级专利检索、专属身份标志、高级客服、多端互通、版权登记。
  7. 7、VIP文档为合作方或网友上传,每下载1次, 网站将根据用户上传文档的质量评分、类型等,对文档贡献者给予高额补贴、流量扶持。如果你也想贡献VIP文档。上传文档
查看更多
电压互感器的原理(The principle of voltage transformer)

电压互感器的原理(The principle of voltage transformer) The principle of voltage transformer The principle of the voltage transformer is that the ratio of the high voltage to the voltage is equal to the number of windings on the high side of the voltage divided by the number of turns on the low-voltage side, that is, the ratio of the voltage to the number of turns. While the number of primary side coil current transformer is little, generally one wire, two side put many turns, so the voltage transformer principle analysis, if an induction to the low voltage, then the two side if open you will feel a very high voltage and voltage. The two side is not more than 2000V, so the two side is strongly not open. On the other hand, because of one and two are connected in series to form a loop, so a voltage current resistance to side induction is equal to a side flow resistance, current two side is equal to the voltage divided by two side two side feel, when when one side of the large current flows, because the current voltage resistance * primary side sensing to equals one side flow, so a voltage increases, a voltage increases two times to the induction voltage is increased, and the two side current is equal to the voltage divided by two side resistance, so the current two secondary side induction to also increases. Voltage transformer wiring mode is very common, the following are common: 1, a single phase voltage transformer is used to measure the relative voltage of the ground or the phase to line voltage 2, using two single-phase transformer with incomplete star, also known as V - V junction, used to measure each phase voltage, but can not be measured relative to the voltage, widely used in the 20KV below the neutral point ungrounded or discharging coil grounding grid. 3, using three single-phase three winding voltage transformer of YN, YN, d0 or YN, y, d0 connection form, is widely used in 3~220KV system, the second winding is used for measuring the line voltage and relative auxil

您可能关注的文档

文档评论(0)

f8r9t5c + 关注
实名认证
文档贡献者

该用户很懒,什么也没介绍

版权声明书
用户编号:8000054077000003

1亿VIP精品文档

相关文档