电脑主板电容好坏测量以及电容替换介绍（Computer motherboard capacitance measurement and capacitor replacement introduced）.docVIP

电脑主板电容好坏测量以及电容替换介绍（Computer motherboard capacitance measurement and capacitor replacement introduced） Computer motherboards, capacitors, good and bad measurements, and capacitive replacement are introduced at 4:08 p. m. Tuesday December 21, 2010, as well as capacitor replacement measurements and capacitor replacement The symptoms of capacitor damage are: 1., the computer automatically restart without reason 2., boot time to boot several times in order to start 3. file missing 4. suddenly blue screen and so on... First, depending on the size of electrolytic capacitor, usually use multimeter R10, R100, R1K block for testing and judgment. The red and black pens are respectively connected with the anode capacitor (before each test, the capacitor discharge), by hand swing to judge the quality of capacitor. If the hands quickly to the right, and then slowly left back in situ, general capacitor is good. If the needle is placed after that has no turning capacitor breakdown. If the needle swing up gradually after the return to a stop position, the capacitor have leakage. If the needle is put up, that the capacitor electrolyte has dried up push lost capacity. As long as the digital multimeter in R * 1K file, contact capacitance feet respectively with two pen, observe the change of the multimeter value. Under normal circumstances, this value should quickly change from small to big, until the overflow is 1. to 0 or 1 if it has showed no change, while the capacitor is damaged. The pointer multimeter measuring the electrolytic capacitor is difficult to judge, if the multimeter shows that infinite capacitor is good, if the resistance is small or zero must be bad! Because the multimeter uses a DC power supply, and the capacitor is blocking the DC power supply. However, the premise is to look at the power supply voltage, careful breakdown of the capacitor. Some of the current capacitors are difficult to judge accurately by the above methods. When the voltage of capacitor value is gr