超薄壁冷弯钢格构梁弯曲性能研究.pdf

The 12th International Symposium on Structural Engineering ANALYSIS OF FLEXURAL CAPACITY OF THE HIGH-STRENGTH COLD-FORMED ULTRA-THIN-WALL STEEL TRUSS BEAM Hao Luo, Qian Gu, Guangyue Ma School of Civil Engineering and Architecture, Wuhan University of Technology, Wuhan 430070, P.R.China Abstract: The flexural capacity of a type of high-strength cold-formed ultra-thin-wall steel truss beam was analyzed mainly by FEM software, considering nonlinearity of material and geometry. It mainly investigated the flexural capacity and failure mode of the high-strength cold-formed ultra-thin-wall steel truss beam, and analyzed the influence of different beam heights on the flexural capacity of the truss beam. The results showed that the main buckling modes of truss beam were local buckling and distortional buckling, which mainly caused by the ultra-thin wall of the members; from the perspective of failure modes, the flexural capacity of truss beam was greatly influenced by the C-type opening cross section of members; and with the increase of beam height, the ultimate flexural capacity and the flexural capacity in serviceability limit state of the high-strength cold-formed ultra-thin-wall steel truss beam increased obviously. Keywords: Cold-formed ultra-thin-wall steel, truss beam, flexural capacity, beam height 1 INTRODUCTION research is urgently needed to guide the design and construction of this new kind of structure system. The paper was based on the As it showed in the work by the authors (Zhou et high-strength cold-formed ultra-thin-wall steel al.,