教你钻出误差小于0.01mm的螺丝孔（Teach you to drill holes that are less than 0.01mm in error）.docVIP

教你钻出误差小于0.01mm的螺丝孔（Teach you to drill holes that are less than 0.01mm in error） Teach you to drill holes that are less than 0.01mm in error Anyone can use a rig in the surface drilling, but with a little bit of thought and practice, you can create a variety of drilling technology skillfully, in order to accurately connect a variety of components, and the error is less than 0.01mm! To achieve this accuracy, you need a drilling machine. An ordinary drill machine is not very expensive, just like a battery drill. As long as you follow these steps, you can drill holes accurately. Fix up two boards or objects that need to be drilled. 1. When you are drilling, clamp the upper plate and the lower plate, or otherwise align the two plates to prevent them from moving back and forth. For example, you can press a heavy load on two boards, they are not so easy to move. Make a mark on the bottom board with the punch. 2. In order to accurately hit two holes in two pieces on the board, you can use a 6.3mm diameter small awl, marking the central hole in each, gently with a hammer to hammer into the surface, do not underestimate this a little shallow nest, this is a very important step. It helps you to punch holes straight up and down two boards more accurately. Dont worry. Try to drill a hole first. 3. Before you start drilling, lets look at the construction of an ordinary rig. Look at my rig. This is a steel high speed drill with 118 degrees of flexibility. You can replace two types of drill (see figure B). Look vertically at the point at which the hole is drilled by the bit. We call it a hole in the hole. Attention, my little tip is right here. Im not going to start drilling right now, so that the material on the surface of the material is pushed out quickly, so that the drill will be able to drill holes in the medium better. However, although the drill can smooth the material out of the material quickly, this thrust may also cause the diameter of the hole you want to drill and exp