g71（g71）.docVIP

g71（g71） Using linear integrated power supply, output voltage 12, output current 1 series DT-9921 digital table, press launch key 6 seconds after test results Frequency saving state, low power state, high power state 138 MHZ 220 mA 690 mA 2700mA 144 MHZ 250 mA 690 mA 2450mA 433 MHZ 280 mA 530 mA 1930mA 460 MHZ 290 mA 550 mA 2530mA 1. on / off Under shutdown, press PWR for more than one second to turn on Power on, press PWR for more than one second to shut down 2. adjust the squelch What is the signal below the intensity?. The original set is 2. I tried 0, there will be no squelch, but 1. So I set it to 1, so the smaller signal will catch it. Method: press [F], [1], and then rotate the tuning button, you can adjust between 0-5, and finally press the front any key to complete 3. select bands Press [BAND] to switch between the 2 bands of 144.000-147.9875 or 430.000-439.975. 4. VFO upper and lower programming This machine supports 144.000-147.9875, but we check to know that level 4 amateur radio stations can only use 144.000-145.8, in order to avoid careless use of 1, 2 level to use frequency, you can set the upper limit of 3. Method: press [BAND] to switch to 144-148 frequency. Press [F], [BAND], and rotate the tuning knob to adjust the menu to PROVFO 3. By pressing [BAND] again, you can see 144/147, 144 of which blinks. Press [BAND] to confirm the 144 frequency, at this time 147 blinks, rotate the tuning knob, change 147 to 145. Press [BAND] to confirm and press [F] to exit. 5. storage channels Method: press [VFO] to press the number key to set the frequency to be stored. Press [F], to the right a memory number flashes, the rotation tuning knob changes to the desired channel, and then press [MR] to confirm. Example: store 433 on channel 1: press [VFO], press 433000, press [F], rotate the tuning knob, adjust the channel number on the right to 1, press [MR]. 6. use channels Method: select the channel by [MR], rotate the tuning knob. 7. frequency of use Methods: press th