adams使用心得（Adams usage experience）.docVIP

adams使用心得（Adams usage experience） ADAMS/View operation experience 1, how to permanently change the boot path of ADAMS? In the ADAMS after the start of each change path is very time-consuming, we are accustomed to their own files in a folder; in fact, click on the shortcut Adams on the right select properties, and then enter the path you want to be in the starting position. Unit 2 in ADAMS You will need to set the unit for the model at first. In all preset units, the time unit is seconds, and the angle is the degree. Can set: The length of the MMKS-- setting is km, the mass is kilogram, and the force is Newton. MKS - set the length of meters, the quality of kilograms, the force for Newton. CGS set the length of CM, the quality of G for diane. IPS - sets the length to inches, the quality of Slug (Slug), and the force to the pound. The setting of the unit system can also be changed during the operation of the model. You can also use your own units in the text box, such as the default angle, the unit degree, and you can use R to indicate radians. I feel inside the ADAMS that it seems to convert all the input from the tape unit into a unified unit. 3, about the coordinate system of ADAMS. When you start ADAMs/View for the first time, a three view axis is displayed in the lower left corner of the window. The coordinate axis is the global coordinate system of the model database. By default, ADAMS/View uses the Cartesian coordinate system as the global coordinate system. ADAMS/View fixed the global coordinate system on the ground. When creating parts, ADAMS/View assigns each component a coordinate system, that is, a local coordinate system. The partial coordinate system of the parts moves along with the parts. The local coordinate system can conveniently define the position of an object, and ADAMS/View can also return the simulation results such as the position of a part - the displacement of a part of the local coordinate system relative to the global coordinate system. Th