退火温度与平整对冷轧热镀锌双相钢组织与性能的影响.pdfVIP

21 10 　 　 　 　 Vol.21, No.10 2009 10 　 　　　　　　　　　　　Journal of Iron and S teel Research October　2009 1 1 1 1 1 1, 2 罗　青, 　赵征志, 　徐　刚 , 　赵爱民, 　金光灿, 　刘光明 (1., 100083;　2., 10004 1) 　:, 。:800 ℃, C-Mn-Cr 。, , 1%, 。 :;;;; :T G142.1　　:A 　　:1001-0963(2009)10-0033-05 Effect of Annealing Temperature and Temper Rolling on Mechanical Property and Microstructure of Cold Rolled Hot DIP Galvanized Dual Phase teel 1 1 1 1 LUO Qing , 　ZHAO Zheng-zhi , 　XU Gang , 　ZHAO Ai-min , 1 1,2 JIN Guang-can , 　LIU Guang-ming (1.Research Institute of M etallurgy Engineering, University of Science and Technology Beijing, Beijing 100083, China; 2.Shougang Research Institute of Technology, Beijing 100041, China) Abstract:High strength cold rolled hot galvanized dual phase steels w ere pilot-produced in laboratory.The effect of different annealing temperatures and temper rolling parameters on the mechanical properties of dual phase steels had been studied.The results show that w hen the annealing temperature is higher than 800 ℃the microstructure of low Si C-Mn-Cr system dual phase steel is composed of ferrite and martensite, and the general mechanical prop- erties is preferable.Temper rolling can remarkably improve the yield strength and YS/TS ratio of dual phase steel and decrease total elongation slightly.When the temper rolling elongation is below 1%, the dual phase steel w ith excellent mechanical properties can be obtained for industry production. Key words:dual phase steel;microst ructure;property;hot dip ga