汇编调试命令（Assembly debug command）.docVIP

汇编调试命令（Assembly debug command） Assembly language debugging DEBUG command detailed 1, display command D D [address] D [scope] If no range is specified, 8 bytes of 16 bytes are displayed at a time. D; the default segment register is DS, the current offset address D DS:100 CS:200 /D D 200:100 D 200; 200 for offset address, default segment register DS D DS:100 110/D 100 L 10 2. modify the command E The E address starts with the specified address and modifies (or continuously modifies) the contents of the memory cell. DEBUG first displays the specified element content, such as to modify, can enter new data; the space bar display the contents of the next unit can be modified, minus key displayed on a unit and can be modified; if not modified, can directly press the spacebar or minus key; enter the end command. II. E address data table. From the specified address, the data storage unit is modified with the data given by the data table. DS:100: F3 AB 8D. 3. Tim orders F F range data table; The data table is written into the memory cell of the specified range. The number of data is large, the number of data is ignored, and the number of data is small, then the data table is reused. F DS:0 L5 01,02,03,04,05 F DS:0 L5 0102030405 (space) F DS:0 L5 FF; 5 bytes of repeated FF 4. display modify register command R R; * display all registers and flags state; It shows the current point CS:IP instruction. A symbol used to display a flag: =1 =0 OF OV NV DF DN UP IF EI DI SF NG PL ZF ZR NZ AF AC NA PF PE PO CF CY NC 5. assembly command A A [address]; start input symbols instruction from the specified address; such as omitting the last unit address, followed by a A command to start the first time; if the A command is used to omit the address from the current start, CS:IP (usually CS:100). Note: write a simple program under DEBUG, that is, use the A command. After each instruction, press enter. Do not enter the command, press enter, or press Ctrl+C to end the assembly. Supports all 8086 s