消防使用说明（Fire service instructions）.docVIP

消防使用说明（Fire service instructions） Foam fire extinguisher applicable caused by fighting such as oil products, grease and other fire fighting. But not for water soluble combustible, flammable liquid fires, such as alcohols, esters, ethers, ketones and other substances of fire, nor fire extinguishing electrified equipment etc.. The method is that the lifting ring of the upper part of the cylinder can be carried by hand, and the fire can be quickly rushed to the fire. At this time, attention should be paid not to make the fire extinguisher tilted too much, not to be taken or turned upside down, so as to avoid mixing two chemicals in advance. When the ignition distance of about 10 meters, you can connect the cylinder upside down, a hand grip ring. On the other hand to hold the bottom ring of the cylinder, the jet combustion at. To extinguish combustible liquid fire, as has been flowing like combustion, it will bubble youyuanerjin injection. The foam completely covered the combustion surface; such as the burning of the container, the inner wall of the container should be at the bubble, the bubble flowing along the inner wall surface, gradually covering fire. Not directly at the liquid jet. In order to avoid the impact due to the jet, but will break up or out of the burning liquid container, expand the scope of combustion. In fighting solid material fires, the jet should be directed at the most violent part of the fire. When the fire is extinguished, as the effective injection distance is shortened, the user shall gradually approach the combustion zone and begin to spray the foam on the burning material until it is extinguished. When used, the fire extinguisher should always remain in an inverted state, otherwise it will break the jet. Portable foam fire extinguishers should be dry and ventilated and convenient use. Do not close to high temperature or may be caused by exposure, to prevent the decomposition of carbonate and failure; to take anti freezing measures in winter.