空压机安装（Air compressor installation）.docVIP

空压机安装（Air compressor installation） This article is contributed by wxj3692012 DOC documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. First, the installation and installation of the selection of the most neglected by the staff. Often after the purchase of the compressor, just find a location, piping immediately after use, there is no prior planning. Not so hasty, but the formation of days after the compressor fault maintenance difficulties and causes of the poor quality of compressed air. Therefore, the choice of a good installation site is a prerequisite for the proper use of the air pressure system. 1. be wide lighting good places, to facilitate the operation and maintenance; 2. relative humidity of air is low, less dust, the air clean and well ventilated; 3. environmental temperature should be below 40 DEG C, because the higher the temperature is, the less the amount of air compressor output; 4. if the factory is poor, dust, shall installation of pre filtration equipment; 5. reserved access conditions may be the installation of crane, so as to facilitate maintenance and maintenance; 6. reserved for maintenance of the space between the compressor and the walls have to be at least 70 cm above the distance; at least 7. compressor from the top space distance of 8. meters; air-cooled unit, install air guide pipe cooling air export the outdoor (see below): 9. water chiller, cooling water supply pressure should be 0.2-0.6MPa, import and export valves should be installed; if the cooling water may be debris, should be equipped with filters. Water quality of cooling water requirements are as follows: the cooling water should be close to neutral, namely hydrogen ion concentration and pH value should be between 6.5-9.5; the organic matter and suspended mechanical impurities are less than 25 mg / L, containing less than 5 mg / L; the temporary hardness is less than or equal to 10o (