佳能2020I复印机维修代码（Canon 2020I maintenance code）.docVIP

佳能2020I复印机维修代码（Canon 2020I maintenance code） Canon 2020I maintenance code E000 thermistor (THI) THI output is less than 100 degrees in 100 seconds after power ON Heater (H1) Heat insurance (FU2) SSR E001 DC controller PCB The output of thermistor THI is over 200 degrees SSR DC controller PCB The thermal resistance of E002 does not reach 170 degrees in 100 seconds after the THI reaches 100 degrees The heater does not reach 175 degrees in 40 seconds after THI reaches 170 degree Thermal insurance DC controller After preheating of E003, THI output drops below 150 degrees E010 main motor (M2) is maintained as 1 for 1 second after the main motor drives the signal Motor drive PCB After the E022 DC controller PCB selected the developer, the CD unit remained in mesh for 1.6 seconds, and the video meshing sensor (PS3) was 1. After the CD unit was selected by the DDC controller, the black developer kept meshing for 1.6 seconds E030 counter (CNT1) is normal if the counter driver is 0 when the counter is ON. If the counter driver is 1 when the counter is OFF, it is normal DC controller PCB E202 exposure system motor (PM1) was not completed in 10 seconds after power ON The original location of the exposure system The sensor will not display the error code in the following situations, but all the keys on the operation panel are locked and the back action of AE is not completed within 3 seconds. In the 5 seconds after exposure, the backward motion is not completed The E204 exposure system motor (PM1) was not completed in 10 seconds after power ON. DC controller PCB The original position sensor of the exposure system was not completed in 5 seconds after exposure E210 camera original position sensor (PS4) begins to rotate for 20 seconds before taking the lens Lens motor (M3) The operation of the camera cable to the DIRECT copy position is not completed. After the DC controller PCB pressed the COPYSTART key for 15 seconds, the operation of setting the duplicates is still not complete