信号机点灯故障（Signal lighting fault）.docVIP

信号机点灯故障（Signal lighting fault） Fault analysis of signal lighting circuit Principle of circuit operation The signal lighting circuit is shown in figure 7-1. Take the two direction outbound signal as an example. The signal lighting circuit is used to control the display of the signal machine, and the driver command is sent directly to the driver. Whether the signal is displayed correctly or not has a direct impact on traffic safety. Therefore, the signal lighting circuit is a security circuit with tightness and reliability. In the lighting circuit, broken line protection is adopted, and the mixed line protection measures of the position method and double break method are adopted. On the basis of interlock conditions, signal lights off to allow, to make the signal degradation; line signal machine prohibit lighting lights, to prohibit signal re opening permission signal (line). Therefore, each signal is equipped with a filament relay to monitor the integrity of the signal bulb. The lighting power supply of the signal machine is generally divided into 4 beams from the indoor power supply screen, and the fuse protection is arranged on the power supply screen, the zero layer of the composite frame and the side of the combination. The lighting power is delivered to the outside by cable. A lighting transformer is arranged in the signal machine, and the lamp bulb is lightened after the lighting voltage is reduced to 12V. There are 4 display states for the low type outbound signal. The 4 display states are controlled by LXJ, DXJ, ZXJ and 2LQJ which are shunting and shunting. The logic relation of a circuit is: Fig. 7-1 signal lighting circuit The normal state of the 1. signal: LXJ: DJ = light, signal light DXJ: 2. only one departure section is free: = LXJ ZXJ = DJ = light, yellow light signal 2LQJ: 3. the two leaving sections are free: = LXJ ZXJ = DJ = light, signal light = 2LQJ 4. when the shunting signal is opened: LXJ: DJ = light, white light signal = DXJ Note: if there are