2009年全国二级建造师水利水电工程实物真题与详解（In 2009 the national two construction division of water conservancy and Hydropower Engineering and detailed physical exam）.docVIP

2009年全国二级建造师水利水电工程实物真题与详解（In 2009 the national two construction division of water conservancy and Hydropower Engineering and detailed physical exam） 2009 two construction division of water conservancy and Hydropower Engineering Management and practice papers First, individual choice questions (20 questions, 1 points each). Each item options, only one of the most to do) 1., according to water conservancy and hydropower project classification and flood standards) (S1252 - 2000) provisions, a pumping station, engineering and other II, and secondly, the building level should be () level. A.2 B.3 C.4 D.5 2. the fineness modulus (Mx) of the sand used in the concrete of a sluice bottom slab is 2.6, which belongs to () sand. In A. coarse B., C. is fine, D. is very fine 2.B [analysis] the fineness of sand is expressed in terms of fineness modulus (Mx). The greater the Mx, the coarser the sand. Mx is coarse sand between 3.7 and 3.1, Mx is between 3 and 2.3, medium sand is Mx, between 2.2 and 1.6 is fine sand, and Mx is between 1.5 and 0.7. 3. the workability index of dry concrete mix is () A. Vebe consistometer B. stratification C. slump D. viscosity 3.A [analysis] for dry concrete workability (slump less than 10mm), using Vebe consistometer (VB) as its workability index. 4. of a hydropower project is located in a narrow valley, on both sides of steep terrain, rock solid mountain river, the whole design diversion cofferdam method, this project should adopt (Guide). A. beam narrow channel B. open channel C. D. tunnel culvert 4.D [analysis] diversion tunnel is the tunnel excavation on the riverbank, in the pit on the downstream cofferdam construction, during construction by the river water discharge tunnel. This diversion method is suitable for the narrow valley, on both sides of steep terrain, rock solid mountain rivers. 5. when the borehole is blasted, the critical hole depth for shallow and deep holes is (m). A.3 B.4 C.5 D.6 5.C [analysis] hole diameter less than 75mm, depth