基于Peakvue 技术的滚动轴承故障诊断① - 计算机系统应用.PDF

2017 年 第 26 卷 第 3 期 计 算 机 系 统 应 用 基于 Peakvue 技术的滚动轴承故障诊断① 1 2 1 2 张 宝 , 刘 波 , 张郑华 , 杨 涛 1( 四川中烟工业有限责任公司 绵阳卷烟厂, 绵阳 621000) 2(西南科技大学 信息工程学院, 绵阳 621010) 摘 要: 滚动轴承作为旋转机械的关键部件, 其运行状态决定设备以及整个系统的性能. 滚动轴承出现故障时会 产生高频的应力波信号, 而 Peakvue 技术能够有效的检测应力波, 运用一种基于 Peakvue 技术的滚动轴承故障诊 断方法. 该方法采用加速度传感器采集滚动轴承振动信号, 利用高通滤波器滤除加速度传感器输出信号中不必 要的低频部分, 按照一定的时间间隔对高频信号和应力波信号进行峰值提取, 并对提取的峰值信号进行包络检 波处理分析故障类型. 应用西储大学轴承数据集进行验证, 结果表明该方法能准确有效地检测出滚动轴承的故 障类型. 关键词: 滚动轴承; 故障诊断; Peakvue; 应力波; 加速度传感器 Fault Diagnosis of Rolling Bearings Using Peakvue Technique 1 2 1 2 ZHANG Bao , LIU Bo , ZHANG Zheng-Hua , YANG Tao 1(Mianyang Cigarette Factory, China Tobacco Sichuan Industrial Co. Ltd., Mianyang 621000, China) 2(School of Information Engineering, Southwest University of Science and Technology, Mianyang 621010, China) Abstract: Rolling bearings are key components in rotating machinery and its running status has an important effect on the performance of the equipment and even the entire system. Rolling bearing failure produces a high frequency stress wave signal, but Peakvue technique could detect effectively, so a fault diagnosis of rolling bearings using Peakvue technique can be used. Acceleration sensor is used to collect vibration signal of rolling bearings, and the high-pass filter is used to filter unwanted low frequency signal from the output signal of acceleration sensor, and peak extraction is used on high frequency signal and stress wave signal according to a certain time interval, and envelope detection is used on peak signal to analyze the fault type. Datasets from the Case Western Reserve University was used for validation, and the results indicate that this method