鹦鹉bebop无人机泡沫塑料鼻子更换 - ifixit.pdfVIP

Parrot Bebop Drone ty rofoam Nose Replacement Parrot Bebop Drone Styrofoam Nose Replacement This guide will teach you how to properly remove and replace the styrofoam nose of Parrot Bebop Drone. Written By : Jamuna Budhathoki © iFixit — CC BY-NC- A www.iFixit .com Page 1 of 5 Parrot Bebop Drone ty rofoam Nose Replacement INTRODUCTION This guide will show the steps needed to remove the EPP (Expanded Polypropylene) or tyrofoam Nose. The tyrofoam nose protects the motherboard and the GP Module. In order to remove the Nose, the battery will have to be removed first. TOOLS: T5 Torx crewdriver (1) iFixit Tech Knife (1) © iFixit — CC BY-NC- A www.iFixit .com Page 2 of 5 Parrot Bebop Drone ty rofoam Nose Replacement Step 1 — Battery  Begin by removing the velcro strap around the battery . Step 2  While holding onto the nose, gently pull the battery away from the nose. © iFixit — CC BY-NC- A www.iFixit .com Page 3 of 5 Parrot Bebop Drone ty rofoam Nose Replacement Step  Once the battery is separated from the nose, push down on the connector and pull the battery away from the connector. Step 4 — Styrofoam Nose