pcb入门教材（PCB primer）.docVIP

pcb入门教材（PCB primer） This article is contributed by sl6606 Pdf documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. . Introduction to printed circuit board What is PCB? Printed circuit boards (Printed, circuit, board, PCB) will appear in almost every electronic device. If there are electronic components in a device, they are also mounted on PCB of different sizes. In addition to fixing various small parts, the main function of PCB is to provide the electrical connections between the parts above. As electronic equipment becomes more complex, more and more components are needed, and the lines and parts on the PCB are becoming more and more intensive. The standard P C B looks just like this. Bare panels (with no parts on top) are also often referred to as P Rin t e d W IRIN g B o a Rd (P W B). The substrate of the board itself is made of insulation, heat insulation and material which is not easily bent. The fine lines can be seen on the surface of the material is copper foil, copper foil is covered in the original on the board, and in the manufacturing process partly etched off, left to the part of a network of thin wires. These lines are called wires (conductor, pattern), or wiring, and are used to provide circuit connections for parts on the PCB. PDF, created, with, pdfFactory, Pro, trial, version, RN wire (C o n u c t o d r P a t t e) To fix the parts above the PCB, we soldered them directly to the wiring. In the most basic PCB (single panel), the parts are concentrated in one side, the wires are concentrated on the other side. So we need to punch holes in the board so that the foot can cross the board to the other side, so the part of the foot is welded to the other side. Because of this, the positive and negative sides of PCB are called Side (Component) and Side (Solder) respectively. If there is some part of the PCB above, it needs to be removed or installed after the p