pfmea（制程失效模式与效应分析）.docVIP

pfmea（制程失效模式与效应分析） PFMEA medical aircraft PFMEA PFMEA analysis principle is the process failure mode and effects analysis (Process Failure Mode and Effects Analysis) the English referred to, is responsible for manufacturing / Assembly Engineer / team mainly uses an analytical technique to maximize the potential failure modes and their associated causes / mechanisms have been considered and discussion. Catalog brief introduction Principle analysis Pattern and consequence analysis process function / requirement Potential failure modes Consequences of failure Gravity Cause / mechanism of failure Current control method Risk level (RPN) Proposed measures Measures, results Case study PFMEA for example in SMT assembly applications Analysis of manufacturing process risk using PFMEA brief introduction Principle analysis Pattern and consequence analysis process function / requirement Potential failure modes Consequences of failure Gravity Cause / mechanism of failure Current control method Risk level (RPN) Proposed measures Measures, results Case study PFMEA for example in SMT assembly applications Analysis of manufacturing process risk using PFMEA Edit this paragraph PFMEA [1]: failure under specified conditions (environment, operation, time), cannot complete its function or product parameter values and cannot be maintained within the prescribed limits, and the cause of rupture of components damage to the phenomenon of the dead in the scope of work. PFMEA Severity (S): the level of the most serious impact of a given failure mode, which is the relative grading result within a single FMEA range. A reduction in severity is achieved only by design change or redesign. Frequency (O): a possible occurrence of a particular cause / mechanism; a description of the possibility of occurrence; the number of levels is relative but not absolute. Detection (D): refers to the manufacturing process or assembly parts before leaving, using second kinds of current process control methods to find