raid 详解（raid 详解）.docVIP

raid 详解（raid 详解） The advantages of 1.2 RAID 1.2.1 has low cost, low power consumption and high transmission rate. In RAID, you can make a lot of disk drive and data transmission, and the disk drive in logic and a disk drive, so RAID can be used to achieve a single disk drive several times, several times or even hundreds of times the rate. Thats what RAID initially wanted to solve. Because the speed of CPU was increasing at that time, and the data transmission rate of disk drive could not be improved greatly, there was a solution to the contradiction between the two. RAID finally succeeded. 1.2.2 can provide fault tolerance. This is the second reason for using RAID because ordinary disk drives cannot provide fault tolerance if you do not include the CRC (cyclic redundancy check) code written on disk. RAID and fault tolerance are built on the hardware fault tolerance capabilities of each disk drive, so it provides higher security. Another feature of 1.2.3 RAID (Parity) is a data check function, check can be described for RAID Level 2, 3, 4, 5 additional information, when a disk failure occurs, check function with intact data in the disk, can reconstruct the data on the disk failure. For RAID systems, the absolute need to maintain data integrity (Data, Integrity) is the most basic requirement under any harmful conditions. Data integrity refers to the ability to keep the face array data is not lost disk failure, due to the destruction of data usually have disastrous consequences, so choose the basic condition of RAID array is the integrity of the data it can provide what level. 1.2.4 RAID is much cheaper than traditional large diameter disk drives at the same capacity. Disk array without redundancy without calibration At the same time, the data distributed in each disk drive, no fault tolerance, read and write the fastest in RAID, but because a disk drive failure will make the whole RAID system failure, so the safety factor rather than a single disk drive is still lower