组装流程说明.PDF

胤橡科技 缔造生活乐趣 组装流程说明 Introduction ofAssembly Process 第一步，光轴轴承的镶嵌 Part I:Theinlay ofopticalaxisbearings 从包装箱里取出如上图所示配件，将轴承用铁锤镶嵌在板材上 Take out the fittings from the box as is shown in the picture above and insertthebearingontheplatewiththehammer 1 胤橡科技 缔造生活乐趣 Attention:Do not knock theblack part ofthe inside bearing,that is the roll ball andtrack,ahammerknockwill crushthebearing As is shown in thepicture,knock the steel cylinder of outer edge ofthebearing circularly,insertthebearingintotheplate slowly. 将板材放平在地面上，用铁锤通过敲击轴承外缘的钢筒，把轴承渐渐 的敲进去。注意要循环的敲打，不要老是敲打一个地方。确保组装上 以后，板材的背面与轴承齐平，如下图 Put theplate on the flat ground,knock the steel cylinder of outer edge of the bearing, and knock the bearing into it gradually.Be careful to knock circularly, do not always knock the same place. Make sure that after the assembly,the back of the plate flush with the bearing, as is shown in the picturebelow. 2 胤橡科技 缔造生活乐趣 3 胤橡科技 缔造生活乐趣 按照下图所示，把轴承和板材组装完毕，切记，不可以组装反了 As is shown in the picture below, after the assembly of bearings and platesisfinished,rememberthatthey cannotbeassembledbackward. 4 胤橡科技 缔造生活乐趣 第二步，机架以及Y轴部分的组装 Part II:Theassembly ofrack andY-axis 5 胤橡科技 缔造生活乐趣 取出如下图所示配件，8跟铝型材以及十个2028角件，框架的组装 都是用的M5长度8MM的螺杆以及T形螺母。 Takeoutthe fittingsasisshown inthepicturebelow,8aluminumprofiles and ten 2028 angle pieces, the assembly of the frame is used for the M5(length of 8mm) screwsandT-nuts. 如下图所示，先将M5长度8毫米的螺杆和T型螺母组合在一起，注 意螺母和螺杆之间上一到两圈的丝就可以，然后贴合在铝型材上，用 内六角扳手转动螺杆，螺母会自动的在铝型材的凹槽内垂直开来，从 而上紧固定。后边类似咬合铝型材的螺丝都是这样的方法组装，后边 不再赘述。 As shown in the picture below, firstly combine the M5(length